2010 Ford Explorer Door Lock Making Locking Noise

For vehicles with traditional style door lock cylinders and keys a bad power door lock relay will merely disable the power door lock feature.

2010 ford explorer door lock making locking noise.

Listen for the vehicle s horn to chirp one time. 1998 ford windstar fuse problem dome light stays on etc you most likely have a bad door ajar switch the door panel has to be removed to access it its on the door latch you can unplug them this will take care of the batt drain prob as for the locks it may be a switch problem most ford vehicles will not let you lock the vehicle from the driver s door when it s open to prevent. It has a electrical actuator. Press the power door lock unlock button one time to command the rap module to toggle the autolock relock feature on or off.

Press and hold both the lock and unlock buttons on the remote for at least two seconds. That may lead you to think the door lock actuator linkage is binding. Inside the module there is a track on which two electrical contacts slide along with the actuator and a small rubber bumper stop. The latch and mechanical lock are the same unit.

In a partial failure you ll hear some noise coming from the door panel and the manual door lock button may appear to move slightly but not enough to completely lock or unlock the door. If you want to reactivate the beep feature. For vehicles equipped with door lock cylinders the door can still be opened using the key. However vehicles without door lock cylinders will not be able to lock or unlock the doors until power is restored.

It was caused by a deteriorated rubber stop inside the door lock actuator module. The horn should honk one time. Lock the doors and confirm that the horn does not sound. You will be able to open the hatch by sliding the lever sideways.

The module is buried down in the lower outside corner of the door. Unusual noises coming from inside the door are one of the first symptoms of a potential problem with a power door lock actuator. Another symptom of a potential problem with the door lock actuators are power door locks that do not function. Power door locks do not function.

Press the power door lock lock button once to enter the command. This will require the driver to use the key to lock or unlock the doors and can disable the power door. In some cars a door lock actuator becomes noisy and produces a squeaking or buzzing noise when the power door locks are locked or unlocked. If the door lock actuators fail they will disable the power door lock feature from working.

If the electric motor or the mechanism inside the door lock actuator wears out the door lock may lock or unlock slowly or work sometimes but not all the time. Turn the ignition switch to the off position to exit the enable disable mode. Your dealer or regular.